Bar's Leaks Engine Repair - 16 oz.

Product Code: 1000
Availability: In Stock ( 5+ Available )

Qty: - +


  • Increases Oil Pressure  
  • Reduces Friction  
  • Helps Clean Internal Parts  


  • Quiets Knocking  
  • Stops Ticking  
  • Raises Oil Pressure  


  • Reduces Oil Burning  
  • Eliminates Smoking  
  • Stops Leaks 

The common element between all of the engine components is the oil. Oil is the lifeblood of the engine and is pumped under pressure to all the moving parts. The two main parts needing oil for lubrication are the bearings and pistons. As the engine ages and gains more miles, the oil alone can’t do the job. Internally, parts don’t fit as tightly as they originally did which causes noise and loss of power. Bearings wear down, seals leak, lifters tick, blow-by passes around tired rings, and power is lost. When installed, Engine Repair helps to stop and prevent these problems and will also extend the useful life of your engine. Engine oils are generally used to reduce friction between moving parts. In addition to lubricating, motor oil must cool, provide corrosion protection and be a method of removing contaminants. As lubricants degrade, their properties change, leading to increased friction and wear. Over time the natural wear that occurs inside the engine causes reduced oil pressure, loss of compression (power loss), lower fuel mileage, oil consumption (leaks & smoking) and noise (knocking & ticking). Bar’s Leaks Engine Repair contains a combination of the best performance additives to repair these most common oil-related problems. Engine Repair restores lost compression and power, reduces noise and oil consumption, while improving the performance of worn cylinders, rings, bearings, and seals. For most vehicles, this is your last chance before paying an expensive repair bill or replacing the vehicle. Engine Repair can be used to top off the existing oil when low, or add a bottle when changing the oil & filter. Compatible with ALL types of engine oils, including petroleum, synthetic and high-mileage formulas.


  • When Adding To Existing Engine Oil Remove engine dipstick and check oil level. If oil is low, remove oil cap and install entire contents of the two chamber bottle. Do NOT overfill. Top off with manufacturers recommended engine oil as needed. Reinstall dipstick and oil cap. Drive/idle engine for 10-15 minutes. Depending on the engine problem, results will either be immediate or noticeable within two (2) days or 100 miles of driving. In engines with seriously damaged components, a second treatment may be required. In this case, it is suggested that the oil and filter be changed, and a second application of Engine Repair be added.
  • When Changing Oil If using Engine Repair when changing oil, add entire contents of bottle after filter is changed. Then refill with manufacturer’s recommended oil to proper level. Drive vehicle and recheck oil level. 

DOSAGE 1 bottle treats 4 to 6 quarts of oil